Gábor Stefanik wrote: > The HW TX power control init still needs work. > The SW init is complete according to the specs. > > Signed-off-by: Gábor Stefanik <[email protected]> > --- > v2: Address Michael's comments, and update for the dummy transmission > changes. > > This depends on both the rev0/1 RC calibration patch and the > updated V4 dummy transmission patch I submitted earlier. > > Larry, please review the SPEC TODO/SPEC FIXME comments! > > drivers/net/wireless/b43/phy_lp.c | 105 > ++++++++++++++++++++++++++++++++++--- > drivers/net/wireless/b43/phy_lp.h | 5 ++ > 2 files changed, 103 insertions(+), 7 deletions(-) > > diff --git a/drivers/net/wireless/b43/phy_lp.c > b/drivers/net/wireless/b43/phy_lp.c > index 2441a8d..b4e51f0 100644 > --- a/drivers/net/wireless/b43/phy_lp.c > +++ b/drivers/net/wireless/b43/phy_lp.c > @@ -1257,18 +1257,109 @@ static void lpphy_calibration(struct b43_wldev > *dev) > b43_mac_enable(dev); > } > > +static void lpphy_set_tssi_mux(struct b43_wldev *dev, enum > tssi_mux_mode mode) > +{ > + if (mode != TSSI_MUX_EXT) { > + b43_radio_set(dev, B2063_PA_SP1, 0x2); > + b43_phy_set(dev, B43_PHY_OFDM(0xF3), 0x1000); > + b43_radio_write(dev, B2063_PA_CTL10, 0x51); > + if (mode == TSSI_MUX_POSTPA) { > + b43_radio_mask(dev, B2063_PA_SP1, 0xFFFE); > + b43_phy_mask(dev, B43_LPPHY_AFE_CTL_OVRVAL, 0xFFC7); > + } else { > + b43_radio_maskset(dev, B2063_PA_SP1, 0xFFFE, 0x1); > + b43_phy_maskset(dev, B43_LPPHY_AFE_CTL_OVRVAL, > + 0xFFC7, 0x20); > + } > + } else { > + //SPEC TODO
Put a WARN_ON(1) here. This branch would be an error. No, I don't understand it either! Larry _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
