Gábor Stefanik wrote: > 2009/8/27 Larry Finger <[email protected]>: >> Gábor, >> >> Congratulations on your progress. With today's patches my BCM4312 >> 802.11b/g card with PCI ID 14e4:4315 works - I'm using it at the >> moment. I'm using WPA2 encryption and have connected to APs on >> channels 1 and 11. My logs are clean. > > That's good to hear! > >> As you noted, performance is a little weak, but I get transmits of >> 9-11 Mb/s and receive rates up to 18 Mb/s - eminently usable. > > What is your actual RX throughput? For me, it's usable up to 24Mb/s, > but the actual throughput is limited to 1.2Mb/s.
That 18 Mb/s receive rate was observed data transfer from my server that is wired to the router/AP and over the air to the BCM4312, just as the 11 Mb/s was observed transfer from the BCM4312 to the server. I have no idea what bit rate was set into the interface. Every time I looked, it was at 1 Mb/s, but the throughput is better than that. --snip-- >> For those of you with N PHYs, the RE of those devices will be my next >> step. > > My next step will be calibration. :-) > > (However, calibration specs are still not complete - there are 2 wlc_* > calls in PR41573. But that only matters for rev.0, and apparently all > 4312s are rev.1.) I missed those (obviously). Are there any other places in the LP PHY that need work? Larry _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
