Larry wrote: >There are a lot of changes in mac80211 between 2.6.31 and 2.6.32, but not >many differences in b43legacy. The AP problems are probably there. OK. Is there anything I can do against "PHY transmission error"? hostapd doesn't continue to work after controller is restarted. I also have the problem that the wlan0-interface shall not be upped with "ifconfig wlan0 0.0.0.0 up" before starting hostapd, otherwise no beacons will be send. The interface must be down before starting hostapd. If I terminate a not daemonized hostapd with CTRL+C and restart if without rmmod+modprobe b43legacy, no beacons are sent, too. And I cannot connect the AP. This happens with the bleeding-edge wireless drivers 2009-11-13.
>I have no way to use a mini-PCI card, which is what I think you have. In any >case, I have a BCM4306/2 chip in a PCMCIA format. I will, however, use that >card to test prolonged ping tests. OK. >When you were downloading with a 1 Mb/s rate set, you only set the uplink >rate. The downlink rate is set by the AP. That is why you got 400 KB/s. Thanks for the info! Daniel _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
