On 11/22/2009 01:03 PM, Chris Vine wrote: > On Sat, 21 Nov 2009 00:15:12 +0000 > Chris Vine <ch...@cvine.freeserve.co.uk> wrote: >> WARM BOOT FROM KERNEL WITH WL MODULE INSTALLED >> >> The patched kernel makes no change on a warm boot in the sense that >> if I warm boot after initialising the wireless device with the wl >> module then the b43 module appears to work correctly, both with and >> without the patch applied. >> >> On the same stress test as mentioned above, I have not been able to >> induce the DMA errors nor kernel warnings. It resolutely refuses to >> do anything except work correctly. > > This is just to say that I have carried out further stress tests today > after warm booting to an unpatched linux-2.6.32-rc8 kernel with the b43 > driver (on the assumption that unpatched is the least favourable case > for the driver). This is a warm reboot from a 2.6.31.6 kernel which had > the wl driver installed. > > I have created an extended period of high speed traffic on my wireless > lan and I cannot induce any errors at all with the b43 driver on a warm > reboot. > > This makes me wonder whether the patch is just (partially) masking the > problem rather than actually dealing with it.
We know that the wl driver does something to the interface that persists across a warm boot - we just do not know what. It does not appear to be done in any of the MMIO traffic - at least I have not seen it in the mmio-trace output. If anyone has a KVM setup using PCI passthrough, it is possible to trace PCI configuration traffic? Have you tried running your system with the patch entitled "[PATCH] b43: Rewrite DMA Tx status handling sanity checks"? It cleared up some of the problems that I was seeing with the open-source firmware. Larry _______________________________________________ Bcm43xx-dev mailing list Bcm43xx-dev@lists.berlios.de https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
