Hi! Markess, Thank you for the welcome. WARNING THIS IS LONG
> Please describe the "kites" you wrote of. The "Kites" were developed, as far as I know, in the UK in the '60s or earlier. They were written about in an early British Dower's newsletter and reprinted in several Australian publications. Some of the Australian who worked with them included Muriel Morrison, Percy Saunders and Frank Moody. There are many variations and most seem to work. One should dowse what is required for a particular site. Rather than post a 600 page manual, I will list some dot points, from which you should be able to get an idea. If you are serious, I can do all the calculations for a project, such as the man on the list who is feeding the local bears. This is the sort of situation where Kites come into their own. In the example below, an area is protected by two pairs of inward facing Kites. In the example of the man with the bears, it may be better served by a number of pairs that are outside the area and each pair protect a section of boundary. The kite works by picking up energy from what ever source, be it schurmann waves, cosmic energy or where ever. (Do we really know what we are working with?). The Kite loads another energy on to this and amplifies it and transmits it to an area. Unlike Field Broadcasters or Towers of Power, which cover an area from a single point, the Kits are in pair, usually two pairs. The "another energy" is the message that we want to put into an area. It may be to tell bears that this is not a good place for bears to be; it may a BD Prep or something to balance the soil. ANTENNA. This is done by the antenna section, usually a seven turn, conical, open oscillating coil. This is simply a spiral around a cone, with the top end ending on the seventh turn and the bottom end changing into a straight wire that goes to the next part. (open oscillating coils are a simple coil, with one end going some where and the other terminating. They can also be seen as induction coils. They "pick up" an ambient or other existing energy and take it some where where something is done to it. Does that make sense?) In our case, make the former to wind the conical antenna coil about inch to nothing over one and a quarter inches. The easiest way is to turn a longer bit of wood to one inch, then cut the cone and the end and you have something to hold onto while you wind the coil. The wire used should be think enough to be self supporting. Leave a three inch tail on the pointed end. WITNESS CHAMBER. The next component is the "witness chamber". Those into Radionics/ Field Broadcasters/ advanced Radiesthesia etc will know this one. It is some sort of structure where the energy from the "witness" can be collected and something done with it. There are many variation of witness chambers. In this one, we will use colour as the witness, so it is intended to accommodate that. If you are using Preps, build it more like those used by Hugh Lovel. I have heard of the prep being taped to the wire between the Antenna and the Main Coil. WITNESS. [A side track to the use of COLOUR as a witness. It has been observed that in any part of the electromagnetic spectrum, there are "octaves" which are repeated. Within the Octaves, there are some frequencies that are attractive to a particular organism (including man), while others are less attractive. In Radionics and Radiesthesia, we are interested in an area less attractive to an organism, rather than to kill something. There are many types of Colour used in this way. One that works very well is to use a number of lengths of coloured thread. We tend to use Anchor brand embroidery thread. They are very standard with their colours, have a good range and readily available. But use what is available. One first works out the "Statement of Intent". This may be:- To make the target area of land unattractive to Black Bears and encourage the Bears to go to the far forest." If you do not have a colour card of the threads, take your pendulum and written intent and go to the local craft shop and ask how many colours are required and allow the pendulum to indicate which they are. Take them home (after paying for them), and dowse the required length of each. Be clear if you work in inches or metric. It may #483 - 16.5 inches, #397 - 13.75 inches, # 186 - 27.25 inches. These are cut to length, ready for below. This is an example, not a "cure" for any thing.] For our example, we will use some PVC water pipe and fittings. For each witness chamber (one per Kite) we will use one 2.5 inch length of one inch (or 25 mm) pipe, one 2.5 inch length of three quarter inch pipe and two "caps" for the one inch. Drill a hole in the centre of one cap to take the tail of the antenna wire. Using the glue for PVC pipe, glue the piece of 3/4 inch pipe inside the cap, in a central position. (Make up how many required at the one time.) When the glue is set, use some silicone sealant to set the tail of the antenna coil in the cap with the tail inside the 3/4 inch pipe. Use a bit of styro foam or cork to steady the tail in the open end of the 3/4 inch pipe. When assembling the Kite, the colour thread is wound around the 3/4 inch pipe and the inch pipe slid over and into the first cap, the second cap seals the chamber. On the outside of the one inch pipe, a seven turn open ended coil is wound, using double sided tape to hold it in place and later covered with good quality insulation tape or heat shrink tube as used in wiring installations and electronics. The coil and it's covering should be so placed to allow both caps to fit. If necessary, use a longer length of pipe. The coil on the one inch pipe links directly to the main coil of the Kite and can be made from the same piece of wire during the construction of the Kite. MAIN COIL. The main part of the Kite is the Main Coil. This is a flat coil of kite shape. It is usually built on a cross of two pieces of timber. It is placed vertically. The horizontal arm may be longer than the vertical, but may be equal. The timber should be rot resistant and half jointed where they cross. The Witness Chamber and the Antenna is attached to the upper part of the vertical arm which extends above the edge of the coil, by enough distance to accommodate them. The coil starts at the top, with the wire from the witness chamber and goes around the "cross" in a spiral, going toward the centre. The spacing is usually 1/2 inch or 10 mm. Use small wire staples or angled saw cuts to hold the wire and terminate it at each end in a manner to hold it tight. The size of the "cross" and the number of turns will need to be dowsed for each site. At the point where the required number of turns finishes, the wire from the coil is then taken to the centre of the "cross" and the Terminal Coil. TERMINAL COIL. The Terminal Coil takes the energy from the Main Coil and transmits it to the site. It is commonly a seven turn or fourteen turn, open ended coil, usually around a 1/2 inch or 12 mm core. The Terminal Coil points into the area to be covered and horizontal, pointing toward the pairing kite. General Notes. On very small sites, one pair of kites can be used. On most sites two pairs, even an acre or so, two pairs are used. Kites are positioned facing each other, usually mid way along opposite side of the area and two or three feet inside any fence. The second pair is usually at some what right angles. They need to be supported so that weather and animals will not move them. They may be about waste high in the centre. Everything to do with them is dowsed to suit the actual location. Above is an outline of what may be the case. Coils maybe either left hand or right hand. The antenna, witness and terminal coils are usually right hand as are most main coils, but some main coils are left hand. Some times one main coil in one pair may be left hand and the rest in the set, right hand. SPECIAL NOTE: Everything polarity at different points (see RS). This is not the same as magnetic polarity. Wire has one end that is left hand and the other end is always right hand. This is determined with the pendulum and the Question: "Show me the polarity of this end of this object, by rotating in the direction of the polarity?" If the pendulum rotates clock wise, it is right hand etc. Now listen very carefully: Energy flows more easily from an area of left hand polarity to an area of right hand polarity, than the reverse. Thus in all Radionic Instruments, Cosmic Pipes and field Broadcasters, it is preferable to have all wires, coils etc, so placed to allow this to happen. This means the top of the antenna coil should be left hand and the tail, right hand, the top of the witness coil should be left hand and then around the main coil, through the terminal coil and at the end of the terminal coil, ending with the right hand. Does this make sense? Even with wrapping the colours in the witness chamber, place them in a right hand direction and coming down in the direction of energy flow, from the left hand end of the tread to end with the right hand end. All such detail aids in the over all operation of the device. > You mentioned several Radionic worker/researchers in England. I have > hear of 3D reagent cards being used in Animal health do you have any > Info on them? You may mean the Meridian System, from Alison Davey. I visited her and spent several days as her guest and was shown the system and we shared our experiences. I bought the whole set off her and have yet to have time to start using them. They show a lot of promise. Lavender Dower says that they offer near instant healing in some cases. An example I was told of involved a very well known horse that had developed and extreme temperature, so high that the Vet was going to put the animal down as none of the conventional things had worked. The owner asked for a one hour stay of execution and rang Allison, who had treated the animal before and had a hair sample for a witness at hand. She immediately went to the Broadcast Room and put the horse on an emergency broadcast of about six of the Meridian Cards, made a cup of tea and when to the Analysis Room to work out in detail the needs of the animal. As she sat down the phone rang and the owner said what ever you are doing keep doing it as the temperature has dropped markedly. Some time later she used additional Radionic methods and within hours the horse was largely recovered and eating. I have seen, them, have them, but yet to experiment with them. The original cards were developed by Alison Davey, Eryn Wolfwalker, Rachel Blackmer and Kate Solisti-Mattelon. Later Alison has extended the range. The cards are about the same size as the well known "Rae" Cards. They come in a number of sets. The first was the FULL SPECTRUM OF COLOUR. Then came CREATIVE LIGHT, PHYSICAL, SUBTLE, CLEANSE, ENDOCRINE, SKELETAL EQUIPOISE, PHYSIOLOGY, HOMEOPATHIC, ENGAGEMENT. Eryn Wolfwalker developed the DIVINE CARDS. Alison developed several sets including the Homoeopathic and also the FLORALIGHT CARDS, which equate to the Bach Flower system. It is an instrument free Radionic methodology. The cards are all highly coloured and very attractive to work with. Alison works largely with horses and dogs, so the system includes many animal specific elements. When doing her original Radionic Training with Keys College of Radionics, she did additional study in Homoeopathics. (In Radionics, we broadcast homoeopathics, flower essences, gem essences etc, directly to the client.) She produced a work based on 88 Homoeopathics, which between them, give the ability to work with most common conditions. There are two sets of Homoeopathic cards, a full or part set based on her research. I am not sure on the availability of the system, but I think one should have training in Radionics before using it. In Australia, I intend to offer it as an optional additional to the Radionic Training. > Lastly did you say the Delwar Camera was lost in a fire? > Has/had this researcher used it in gardening & assessments of BD prep > etc? Those involved claim to have used it, but when pushed on specifics, I do not think they get it to work. If you have read Lavender Dower and others on the de la Warr Camera, Leonard was need to actually touch the glass plates, [Yes they were actually glass plates, I saw some of them, when in England.] There were something less than six cameras made and the only one in use that I can track down is in the US and used in Agricultural Radionics. The one in Australia belonged to the late Muriel Morrison, who died nearly twenty one years ago. On her passing it passed to her star student and was lost in the fire. I hope the above is of interest, Gil
