On the "image" SD, both 22 and 80 are open, and openssh-server is
running. I edited /etc/network/interfaces to be the same on the
'compiled version' SD, but no ports are open.
On 13-10-07 03:59 PM, Robert Nelson wrote:
On Mon, Oct 7, 2013 at 2:58 PM, Robert Nelson <[email protected]> wrote:
On Mon, Oct 7, 2013 at 2:49 PM, Bit Pusher <[email protected]> wrote:
Thanks George, I actually do want to boot the operating system on the SD
card which has two partitions made according to instructions at
http://eewiki.net/display/linuxonarm/BeagleBone+Black. The operating system
I installed on the SD card is ubuntu-13.04-console-armhf-2013-07-22.tar.xz.
The LEDs are operating as I expect from booting my other image (which also
boots the SD card) but was a downloaded image as opposed to a compiled
image. When I apply power, the LEDs light up after a few seconds as
expected. When I hold the reset switch down, then after about 8-10 seconds,
the LEDs turn off, again as expected when an SD running machine is turned
off. Everything looks right except for the closed ports.
So 'ssh' should work by default with the console image. Two potential
issues i see, your using a static IP. Can i assume you've tested
pinging this device from another pc on your network? Second, are you
using the raw ip address with ssh, or the device name?
Either way, openssh-server is installed by default, with the default
port 22 configuration..
In fact, port 80 should also be alive with apache, I'm thinking your
network is NOT actually setup correctly..
Regards,
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups "BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/groups/opt_out.
