That is correct. Connect to the Host USB port on the BBB. That is the one that you have to remove the 5V wire from, inside the cable. The microUSB on the board is not used in this setup.
1-HDMI cable to the board. USB Host on the board to USB cable on the dock, 5V wire removed. Gerald On Fri, Oct 11, 2013 at 12:21 AM, <[email protected]> wrote: > > > On Wednesday, September 4, 2013 8:38:32 AM UTC-7, Gerald wrote: >> >> >> You will need to cut the 5V wire on the USB cable to get it to work. The >> Dock and the board both source 5V. >> >> >> Gerald >> >> >> > I am sure this will sound like a dumb question, and I am pretty sure I > know the answer. For the keyboard and touch pad to work; I need to connect > the DATA leads (green&white) from the micro usb male on the the dock to a > male USB A on the BBB? If I go to the mini USB on the BBB it will not work. > Is that correct? Currently I have the power leads (red&black) going from > the mini usb to a barrel jack and that is powering the BBB from the Atrix > Dock. > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
