If you are using ADC adapter which has interlaced output only then you need to make required changes in the kernel/bootloader to set FID pin in P10 socket in BB-xM. Even I have done this changes, it seems the current drivers (CCDC/V4L2) doesn't support the interlaced video input. I mean I couldn't find any driver code who uses FID (Field Indicator - EVen/Odd) signal. Is anyone in the position to confirm this finding?
Regards, Ozkan. On Wed, Oct 9, 2013 at 10:20 AM, <[email protected]> wrote: > An important note if you are going to use your own camera adapter card > instead of LI5M03, BB-xM camera port (P10) is expecting "frame_valid" and > "line_valid" signals in VSync and HSync pins. So, you may need to make some > design changes at outputs of ADC chip that used in your board in order to > satisfy the requirement of BB-xM. > > Regards, > Ozkan. > > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to a topic in the > Google Groups "BeagleBoard" group. > To unsubscribe from this topic, visit > https://groups.google.com/d/topic/beagleboard/xx7SlIpiNds/unsubscribe. > To unsubscribe from this group and all its topics, send an email to > [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
