Thank you Gerald for the instruction. I am a new user, not much comfortable with this. I checked the version of BBB eMMC it same as that of the image I downloaded. *CLoud9 GNOME Image 2013.06.20. *Do i need to flash it again on BBB?
On Wednesday, October 23, 2013 11:39:37 PM UTC+5:30, Gerald wrote: > > I suggest that you go to > http://circuitco.com/support/index.php?title=Updating_The_Software and > follow the instructions there. Holding the boot button that long is a wast > of time. > > Gerald > > > > On Wed, Oct 23, 2013 at 12:49 PM, <[email protected] <javascript:>>wrote: > >> Hi, >> I have the same problem,I have not deleted any files. I have downloaded >> image of angstrom kernel and file-system from below link. >> https://s3.amazonaws.com/**angstrom/demo/beaglebone/** >> Angstrom-Cloud9-IDE-GNOME-**eglibc-ipk-v2012.12-** >> beaglebone-2013.06.20.img.xz<https://s3.amazonaws.com/angstrom/demo/beaglebone/Angstrom-Cloud9-IDE-GNOME-eglibc-ipk-v2012.12-beaglebone-2013.06.20.img.xz> >> >> >> and followed the procedure to boot through SD Card given by the following >> link. >> >> http://www.beagleboard.org/**Getting<http://www.beagleboard.org/Getting%20Started#update> >> >> Initially I have been holding the BOOT/USER button and power up the BBB >> board all 4 LED's will lid up, >> By then I release the BOOT button, there after only 3 LED's start >> blinking USR0, USR1 and USR2 nothing happens. >> Can you please suggest what has to be done to boot it properly? >> >> >> Thanks & Regards >> Harsha >> >> >> On Sunday, July 28, 2013 8:59:07 PM UTC+5:30, [email protected]: >>> >>> Reformated the whole card using Linux to NTFS and then FAT and reflashed >>> the card using dd and putting it in an adaptor seems to have done the >>> trick. Its booted and is going through the process of reflashing the eMMC. >>> I'm getting sense out of the serial now. >>> >>> Thanks for the clues. >>> >>> OK, I'm convinced - you can't brick a BBB. >>> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected] <javascript:>. >> For more options, visit https://groups.google.com/groups/opt_out. >> > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
