Hello, I'm trying to read from a LV-Maxsonar-EZ0 using the serial interface.
I have connected the wires correctly and I have placed an overlay in uart2. The problem is the data I'm reading from the sensor. I can only get garbage, but its not completely wrong because the data changes according to the distance to obstacle. The datasheet for the sensor can be found here: datasheet<http://www.maxbotix.com/documents/MB1000_Datasheet.pdf> . I searched google for a day and couldn't find anything... Someone posted in a raspberry pi forum that the problem is the meaning of 1s and 0s, but I changed active_low to 1 and I got the same. I'm not very proficient with electronics, so I might take some time following instructions. Nonetheless all the help will be welcome. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
