This is not expected behavior. Although, it may be explained once it is understood as to what is going on..
Gerald On Fri, Nov 22, 2013 at 8:41 AM, Bert Lindner <[email protected]> wrote: > > Just had a 5V powered Beaglebone Black seemingly die on me. First the > power led kept blinking, then after removing the (BB Toys CAN) cape the > power led would flash just once after applying power. Looking back in > previous threads this seemed to mean I killed the board somehow; there was > also a GPS module attached to one of the UARTs and a probably power hungry > USB wlan stick that I'm trying to get to work, so a power hungry setup. > > I was ready to declare it dead, it remained just flashing once after > repeatedly unplugging and reattaching the power supply. > > However I noticed the single power led flash would also happen if I > pressed the power button (leaving the 5V plug in). Doing that repeatedly > seems to have revived the board, will see if new problems occur. For now it > behaves normally. > > Is this expected behaviour? > > Best, > > -Bert > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
