>From Beaglebone schematic, the EEPROM is to store MAC Address and Variables, can you provides codes on what variables do I need to set and how to set MAC Address and Variables? Thank you.
On Wednesday, November 20, 2013 7:49:37 AM UTC-6, Víctor MV wrote: > > Hi Victor. I used an older version of Angstrom which let me access u-boot > with my BB clone. Once there i was able to use the commands that Gerald > suggested above to read/write the EEPROM memory. > > Regarding the commands i wrote them above. You just have to make sure you > use the *expanded address format *(also mentioned above). > > El miércoles, 20 de noviembre de 2013 14:40:57 UTC+1, victorleite escribió: >> >> Hi Victor MV, >> >> I'm also cloning the same board (beaglebone white). >> >> I've read the entire discussion but I'm not sure what steps you've been >> through for write the EEPROM. >> >> Did you modified the u-boot or just used an older version? >> >> What are the right i2c commands for writing the EEPROM? >> >> Thank you very much! >> >> Victor Leite >> >> >> On Friday, September 6, 2013 8:56:47 PM UTC-3, Víctor MV wrote: >>> >>> Apologies. What i meant is that "I'm now able to ..." >>> >> -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
