William, Thanks you for responding.
*" Need more information. What is your exact problem ? "* I'm not getting any data back from the from the arduino while its plugged up to the UART ports. I tried using UART2 and 4 but can't get anything back. Both my arduino and the BBB set for the baud rate of 9600. *"What are the exact steps you took ? "* I have a arduino device that I normally use FTDI to communicate with. Using the device tree solution, I created a new device tree and changed the mode of ports 21 & 22 to mode0. Then, plugged up the power to the 3.3v of the BBB and the rx/tx (opposite on the BB end)...but no data. ...again, thanks for responding. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
