I have been using Angstrom for a little while now, and now am attempting to install Ubuntu 13.10 on my BeagleBoard-xM using the following procedure:
http://elinux.org/BeagleBoardUbuntu#Method_2:_Use_the_NetInstall_method I setup the boot partition on my SD card without any issues using the following command from the netinstall git repository mentioned above: $ sudo ./mk_mmc.sh --mmc /dev/sdf --dtb omap3-beagle-xm --distro saucy --serial-mode I have tried toggling the console parameter between ttyO2 and ttyS2 with no luck. I get the following initial output from U-Boot: U-Boot SPL 2013.10-00015-g0880266 (Nov 08 2013 - 16:10:03) reading u-boot.img reading u-boot.img U-Boot 2013.10-00015-g0880266 (Nov 08 2013 - 16:10:03) OMAP36XX/37XX-GP ES1.2, CPU-OPP2, L3-200MHz, Max CPU Clock 1 Ghz OMAP3 Beagle board + LPDDR/NAND I2C: ready DRAM: 512 MiB NAND: 0 MiB MMC: OMAP SD/MMC: 0 *** Warning - readenv() failed, using default environment In: serial Out: serial Err: serial Beagle xM Rev C No EEPROM on expansion board No EEPROM on expansion board Die ID #1db400029ff800000146a60619011009 Net: usb_ether Hit any key to stop autoboot: 0 mmc0 is current device gpio: pin 173 (gpio 173) value is 0 gpio: pin 4 (gpio 4) value is 0 SD/MMC found on device 0 reading uEnv.txt 983 bytes read in 3 ms (319.3 KiB/s) Loaded environment from uEnv.txt Importing environment from mmc ... Checking if uenvcmd is set ... Running uenvcmd ... Installer for [saucy-armhf] is using the Serial Interface reading zImage.net 3417384 bytes read in 211 ms (15.4 MiB/s) reading initrd.net 22513335 bytes read in 1375 ms (15.6 MiB/s) Kernel image @ 0x80300000 [ 0x000000 - 0x342528 ] Starting kernel ... Uncompressing Linux... done, booting the kernel. At this point, I get no additional output on the serial device. I also reformatted the MMC without the --serial-mode parameter, hooking up my DVI monitor. I get a yellow/orange screen during U-Boot initialization, and then I get no display. Does anyone have any advice? Thanks! -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
