Some more information: I'm running the BeagleBone Black with a 3.8.13-bone33 kernel.
Op donderdag 26 december 2013 09:42:12 UTC+1 schreef Ives van der Flaas: > > I have two GPIO pins that I'd like to be high during the boot process. > These pins, GPIO 44 and 23, are connected to LEDs through some circuitry. > I've managed to set those pins when uBoot runs, but they are reset during > the boot process: as soon as the linux kernel starts these pins are pulled > low. After linux finishes booting I install a device tree overlay and can > resume control of the pins. > > How can I prevent these pins from being cleared? Is this done by the linux > kernel itself or some driver? How do I start looking for the code > responsible? > > (I also posted this question 3 days ago but it hasn't appeared in the > relevant group). > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
