Did you check the support Wiki? http://www.elinux.org/Beagleboard:BeagleBoneBlack http://www.elinux.org/Beagleboard:BeagleBone_Black_FAQ http://www.elinux.org/Beagleboard:BeagleBone_Black_FAQ#Capes http://www.elinux.org/Beagleboard:BeagleBone_Black_FAQ#What_is_the_process_for_disabling_the_HDMI_and_eMMC_Virtual_Capes.3F
Gerald On Fri, Jan 10, 2014 at 3:46 AM, <[email protected]> wrote: > Hi, I am very beginner of BBB. > I'm planning to develop a machine and want to control it by BBB via the > expansion headers (P8 & P9). > To control the machine, 2 serial outputs (TXD/RXD) and 39 IO pins are > required. Is it possible? > > Though I referred the BBB schematics, many processor signals of the > expansion headers were already connected to eMMC or HDMI interface. > I don't use HDMI. Is it no pobrolem to use the signals for the HDMI > interface? > And which signal pin mode (mode 0 - 7) should I select? > Please tell me. > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
