You would need to boot from SD and then load from the SSD over the USB. The BeagleBone Black is more suited for 3D printers as there are several projects and products that use it..
Gerald On Wed, Jan 15, 2014 at 12:03 AM, David Freeman <[email protected]>wrote: > I have been playing with a Raspberry Pi and am building a wireless robot > controller with a 64gb ssd. I haven't found out if I can replace the slow > SD card to boot and run with a partition of !024mb of swap to speed up > operations. > > Anyone use BB xm to run 3d printers? > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
