Sounds like something may have died. But it is rather hard to debug hardware via email. I suggest that you try an RMA request and get it looked at.
Gerald On Sun, Feb 9, 2014 at 9:02 PM, rolf schatzmann <[email protected]>wrote: > Hi All, > > I have a BBB Rev A6 (SN 3913BBBK1414) that I purchased from Sparkfun in > November 2013. It has been running Ubuntu perfectly since it arrived in > Dec. It has been running on a regulated 5v power supply and housed in a > case. > > A couple of days ago it stopped responding and then I checked it the PWR > LED was illuminated but none of the others. > > Nothing I did would get any of the USER LEDs to light up. > > Connecting serial to the J1 header gives me the following output: > > U-Boot SPL 2013.04-00017-g5c4fa11 (May 03 2013 - 10:48:32) > timed out in wait_for_pin: I2C_STAT=0 > Could not probe the EEPROM; something fundamentally wrong on the I2C bus. > Could not get board ID. > Unknown board, cannot configure pinmux.### ERROR ### Please RESET the > board ### > > All attempts to flash a different image or boot from the SD card fail with > the same message. I gather that the EEPROM has lost it's ID. > > Is there anything I can do to fix this or has the EEPROM died? > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
