Hey brian smith have u worked on kinect after connecting into beagle bone.... ?? my kinect s recognized by the BBB ... wat should i do after tat
On Thursday, 1 August 2013 05:36:52 UTC+5:30, Brian Smith wrote: > > Hello Isaac, > > I have the Kinect running on my Beaglebone using a powered USB hub. I'm > not sure if that's why you're having the problem or not; I actually ran > across your post while researching if the powered USB hub is necessary when > connecting the Kinect to the BB since I want to get the whole setup mobile > on batteries or something. > > The USB hub that I'm using is Belkin model#: F4U040. > > Brian > > On Wednesday, July 24, 2013 12:53:15 PM UTC-7, Isaac Flores wrote: >> >> >> >> On Wednesday, July 24, 2013 12:02:18 PM UTC-7, Gerald wrote: >>> >>> What you describe is the way it works. You have to have the device or a >>> Hub plugged in on power up for it to be recognized. >>> >>> Gerald >>> >>> >>> >>> On Wed, Jul 24, 2013 at 1:54 PM, <[email protected]> wrote: >>> >>>> Hello, >>>> >>>> I booted my BeagleBone Black A5B with Raring Ubuntu 13.04. I used the >>>> image from: >>>> >>>> http://rcn-ee.net/deb/rootfs/raring/ubuntu-13.04-console-armhf-2013-07-22.tar.xz >>>> >>>> I followed the steps from the elinux.org using the sd_setup script. Then I >>>> was able to install OpenCV, OpenNI,and PrimeSense Kinect Driver. >>>> When I plugged in the Kinect, the board did not read it and the Kinect did >>>> not power on. I tried *lsusb *and it was not reading the Kinect. >>>> >>>> Then *dmesg | tail* gave me the following : >>>> *[ 5981.901031] gadget: sending command-failure status* >>>> >>>> >>>> After this I tried to connect my logitech webcam. The board did not read >>>> as well, so then I rebooted the board with with the camera plugged in the >>>> >>>> usb port. Once it booted the camera was recognized. I then tried the same >>>> with the Kinect, but it still did not turn on the Kinect camera. After >>>> that I >>>> tried using a USB splitter, more specifically a "Media-To-Go.com 7-in-1 >>>> Card Reader with USB HUB". In order the USB Hub to work, I had to reboot >>>> with it plugged in, >>>> >>>> I then connected the Kinect to this and it turned on. Also *lsusb *showed >>>> the Kinect was working. So I tried running an OpenNI sample program but it >>>> would fail saying the Kinect was not connected. >>>> >>>> So is there something wrong with my USB port? My driver? Also do I need to >>>> reboot the board with a device plugged in for it to read it? >>>> >>>> Any help will be greatly appreciated. Thank you in advanced! >>>> >>>> >>>> >>>> >>>> -- >>>> For more options, visit http://beagleboard.org/discuss >>>> --- >>>> You received this message because you are subscribed to the Google >>>> Groups "BeagleBoard" group. >>>> To unsubscribe from this group and stop receiving emails from it, send >>>> an email to [email protected]. >>>> For more options, visit https://groups.google.com/groups/opt_out. >>>> >>>> >>>> >>> >>> -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
