I removed the microSD card after the flashing process, then I did a reboot. What do you mean by power cycle the board after boot process?
I did turn on and off the power supply twice to reboot the board, but still it doenst boot by itself On Sunday, 23 February 2014 22:44:36 UTC+5:30, Gerald wrote: > > After you flash the eMMC, make sure you remove the uSD card. Otherwise it > will try and flash it again and if you stop that process, will not boot. > Also make sure you power cycle the board after the reflashing process. > > Gerald > > > > On Sun, Feb 23, 2014 at 10:19 AM, Pariyan Shah > <[email protected]<javascript:> > > wrote: > >> All of a sudden my BBB would not boot up. So I decided to flash the eMMC >> image. Followed steps from - >> http://www.elinux.org/Beagleboard:Updating_The_Software >> >> I had no issues following them step by step and got all USRs brighten at >> the end of process (yes, took around 45~55 min) >> But the BBB doesnt boot after flashing. Please help me out, I am not able >> to figureout the problem. >> >> >> >> >> P.S.- I then downloaded another the image for booting directly from >> microSD. This process worked for me, but I am not able to connect to >> internet. I feel there are problems because I am using microSD for booting >> it. >> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected] <javascript:>. >> For more options, visit https://groups.google.com/groups/opt_out. >> > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
