Here is how to reflash the eMMC to factory condition. http://www.elinux.org/Beagleboard:Updating_The_Software
Here is the link to the support Wiki. http://www.elinux.org/Beagleboard:BeagleBoneBlack Gerald On Tue, Mar 4, 2014 at 8:12 PM, <[email protected]> wrote: > Hey folks, first time poster here, having some trouble getting my BBB to > boot. > > Here's the story - I was previously booting fine and connecting to the > bone with both serial and ssh over the network. Then I installed OctoPrint, > a 3d printing controller. All was well, then installed mjpg-streamer and > tested - also working fine. Basically I then powered everything off and > went home. Now it won't boot - it will blink a little and then the lights > go out. It won't power on at all until I unplug power and try again, when > it does the same. > > In the mean time I did image LinuxCNC MachineKit onto an SD card, and it > will boot from that - so I can get into the board, but the onboard boot > seems hosed. I'm used to working with Arduino, where you just yank th eplug > when you're done - this seems more sensitive and I guess my lack of orderly > shutdown (I actually don't even know how to do that yet :-) ) something > went wrong. > > Any suggestions for how to repair the boot? I guess I could reimage it but > then I don't exactly know how to do that on the eMMC either. Is it > generally considered a good idea to move away from Angstrom? > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
