Hi, forks!
I got BBB and start enjoying.
I wonder How to work pullup pinmode at input in software.
http://beagleboard.org/Support/BoneScript/pinMode/
I want to pull up P8_31(GIPO_10) as Input 、but it effect noting.
1.b.pinMode("P8_31",
b.INPUT_PULLUP<http://beagleboard.org/support/bonescript#input_pullup>
);
2.b.pinMode("P8_31",
b.INPUT<http://beagleboard.org/support/bonescript#input_pullup>,
7, 'pullup');
Both are in same result and P8_31 never pulluped.
Of course <http://ejje.weblio.jp/content/of+course> when I connected a
10Kohm resister between P8_31 and VDD3V3 , It pulluped and work fine.
I want to omit this resister.
Many chips (PIC & AVR & etc..) has software pullup mode and no need to
connect extra resister. But In BBB It doesn't work?? Always need extra
resister?
My BBB's info:
*Your board is connected!*
BeagleBone Black rev 00A6 S/N 4613BBBK1318 running BoneScript 0.2.2 at
192.168.7.2
I want some help, Please.
Thanks.
P.S.
I know in BBB it is limited 4mA or 6mA for GPIO current.
My question is total current limitation in BBB. Is there any limitation for
total current?
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups
"BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/groups/opt_out.
