On 03/10/2014 04:57 PM, [email protected] wrote:
I want the ability to use uart0 on Pins 9,17 and 9,18. along with the
handshaking lines. According to the table on the BBB reference guide I
know this is possible. I have the dts file posted below, compiled it
and copied the dtbo file to /lib/firmware. I run the command to
activate it and I am not seeing any change in the pin configurations.
Has anyone been sucessful connecting uart0 the header? Thanks
If memory serves you can't use uart0 on either of the headers. It's
assigned to J1 (again if memory serves) on the board as the debug/serial
port.
Mike
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups "BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
