Hello,
I am using beaglebone black with ubuntu(3.8.13-kernel). I want to
interface 7" TFT-Lcd with baglebone black. I designed a hardware with
tranceiver (buffer) IC74AVC16T245 which is connected to GPIO ports of
beaglebone black. And 40 pin LCD connector is connected to output of
tranceiver IC. OE pin is connected to ground. DIR pin is also connected to
ground.
Now, I am facing a problem with hardware. If I connect this hardware
with beaglebone black, beaglebone black is not booting only power led is
on. When I remove that hardware, beaglebone black board is booting
properly. I tested a hardware but I didn't found any mistake. Can i get
some guidance or idea to solve this problem?? Thanking you.
Regards,
Kishor.
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups
"BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
