On Wed, Apr 23, 2014 at 4:22 PM, Ross Morrison <[email protected]> wrote: > On 04/23/2014 02:07 PM, Robert Nelson wrote: >> >> On Wed, Apr 23, 2014 at 4:06 PM, Ross Morrison <[email protected]> wrote: >>> >>> Just want to confirm that the current U-Boot, 2014.04, still has problems >>> with the i2c nm and i2c mm commands (unable to write to the ID EEPROM on >>> the >>> BBB baseboard). >> >> Did you un-write-protect the board eeprom? >> >> Regards, >> > Pulled pin 7 (WP) to ground, yes. I've made the changes to U-Boot to skip > the check of the ID EEPROM and I'm now, through U-Boot, trying to program > the baseboard ID EEPROM with a proper signature. Linux version > 3.8.13-bone35.1 starts to boot, but issues a Kernel Panic as seen here in > the console output:
Odd, it's working fine here: ( 3.8.13-bone47) http://pastebin.com/BhgMbw4S > This is our custom board and I'm trying to eliminate any unknowns by getting > a good ID EEPROM signature setup up. > > So, is U-Boot good to go, or should I get an older version from a BBW to get > the EEPROM programmed? Is this a clone of the BBB? and using a 1Ghz cpu? https://github.com/RobertCNelson/Bootloader-Builder/blob/master/patches/v2014.04/0002-NFM-Production-eeprom-assume-device-is-BeagleBone-Bl.patch Regards, -- Robert Nelson http://www.rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
