Hello all, what is the correct mode value for PRU r30 (output) mode? I am finding conflicting information:
http://elinux.org/Ti_AM33XX_PRUSSv2 - the table on this page lists mode 0x25 for output and 0x06 for input 0x25 would be 0x20 (IEN - input receiver enabled?) | mode 0x05 0x06 would be just mode 0x06 with IDIS - receiver disabled Is this correct? Why does it have the receiver enabled for output and disabled for input? For pru0_r30_14 and pru0_r30_15 it also lists mode 0x25, but from what I can find in other tables, those require mode 0x06 for output. Shouldn't that then be 0x26? Note 1 and Note 2 on that page say you have to put GPIO0_20 and GPIO0_7 into input mode to use pru0_r30_4 and 6 what is the correct mode for that? I came up with 0x2f (mode 7 for gpio | IEN) but I'm not so sure now. thank you Florian -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
