I setup my serial ports on the BBB to have a 1Mbaud rate. However, when I look at the output on the logic analyzer, I see the baud rate is more like 1.214 MBaud. This of course is too much deviation for my serial transmission to sync up. I tried setting a custom baud rate, and that just fails completely. I wanted to use all four uarts. If I need to, I could bit bang it from the PRU (but then limit myself to two versus four). Is there a way to setup a more accurate baud rate on the BBB?
-- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
