Hi, Maybe this will help you get started with your new RS232 Cape http://elinux.org/BBB_RS232_Cape_RevB_Getting_Started
-Hieu On Mon, Jun 9, 2014 at 9:09 AM, Robert Nelson <[email protected]> wrote: > On Sun, Jun 8, 2014 at 12:04 PM, Raphael Philipe <[email protected]> > wrote: > > Hi there, > > > > Has someone used the new RS232 cape REV B before? Do you have > > references on how to use it? > > > > I need to use it to control a gsm board through AT commands and I have > > no clue where to start. > > > > Is it possible to use the older version of RS232 cape documentation as > > a reference? > > > > > > My basic guess and feelings are that: > > I need to load a device tree overlay in order to set the pinmux, load > > device drivers and the like. After that I will be able to communicate > > with the other device throughout /dev/ttyAS0 and so on. Is that > > correct? > > /dev/ttyOx > > What jumper position are you currently using? > > Regards, > > -- > Robert Nelson > http://www.rcn-ee.com/ > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
