I will check into this. In the meantime, check the processor datasheet. http://www.ti.com/product/am3358
Gerald On Thu, Jul 17, 2014 at 9:47 PM, <[email protected]> wrote: > Hello, > > In the C.1 version of the reference manual, Section 8.1.2 begins with a > statement about the 10 eMMC pins connected to pin 8 and listed in Table 16. > > Then it says that the proper mode is MODE2. > > Yet most of the pins listed in table 16 are given as MODE1. > > Table 12 of the same reference manual version lists MODE1 mmmc1 pins as > 22-26 and MODE 2 pins as 11-21. > > So is table 16 wrong in listing MODE1 pins as conflict pins? After all, > the "proper" mode is MODE2 whatever that means. > > I would like to use GPIO1[0..5], but can't really sort out if there is > a conflict with the mmmc1 pins since I can't understand the meaning of the > "proper" MODE2 wrt Table 16's mostly MODE1 pins. > > Thank you for your help > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
