Hi Abhishek, did you figure out the problem??
On Thursday, June 5, 2014 1:53:43 PM UTC-7, Abhishek Kumar wrote: > > Hi Robert , > > As you mentioned i tried but still same problem . > > board=am335x > > board_name=A335BNLT > > board_rev=0A6A > > Disk /dev/mmcblk0: 1983 MB, 1983905792 bytes > 4 heads, 16 sectors/track, 60544 cylinders, total 3874816 sectors > Units = sectors of 1 * 512 = 512 bytes > Sector size (logical/physical): 512 bytes / 512 bytes > I/O size (minimum/optimal): 512 bytes / 512 bytes > Disk identifier: 0x00000000 > > Device Boot Start End Blocks Id System > /dev/mmcblk0p1 * 2048 100351 49152 e W95 FAT16 > (LBA) > /dev/mmcblk0p2 100352 3874815 1887232 83 Linux > > is it correct partition??? > > > U-Boot SPL 2014.04-dirty (Jun 05 2014 - 20:31:45) > > ** Partition 1 not valid on device 0 ** > > spl_register_fat_device: fat register err - -1 > > ### ERROR ### Please RESET the board ### > > boot from eMMC then on u-boot prompt i tried to run few commands > > *U-Boot# fatinfo mmc 0:1* > > *** No partition table - mmc 0 *** > > U-Boot# mmcinfo > > Device: OMAP SD/MMC > > Manufacturer ID: 84 > > OEM: 5446 > > Name: MSTran Speed: 50000000 > > Rd Block Len: 512 > > SD version 2.0 > > High Capacity: No > > Capacity: 1.8 GiB > > Bus Width: 4-bit > > What can be the issue Hardware ?? > > Thanks > > Abhishek > > On Monday, June 2, 2014 6:18:23 PM UTC+5:30, RobertCNelson wrote: >> >> On Sun, Jun 1, 2014 at 6:02 AM, <[email protected]> wrote: >> > Hello >> > >> > I am trying to boot BBB from uSD card but uboot is not working as >> expected , >> > I am getting this error >> > **Partition 1 Not Valid on device 0*** >> > SPL:fat register err --1 >> > >> > I am using 8GB uSD card . >> > I tried to do little debugging actually MLO fails while registering >> FAT >> > partition. >> > ->fat_register_device >> > >> > If you could help. I am using latest rev of BBB >> >> It's either a bad build of u-boot or your partition setup is wrong. >> >> Please take a look and review: >> >> >> http://eewiki.net/display/linuxonarm/BeagleBone+Black#BeagleBoneBlack-Bootloader:U-Boot >> >> >> >> http://eewiki.net/display/linuxonarm/BeagleBone+Black#BeagleBoneBlack-SetupmicroSD/SDcard >> >> >> Regards, >> >> -- >> Robert Nelson >> http://www.rcn-ee.com/ >> > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
