printenv 2014-10-02 14:15 GMT+04:00 Nital Patel <[email protected]>:
> OMAP3 Beagle board + > LPDDR/NAND > I2C: > ready > DRAM: 256 > MiB > NAND: 512 > MiB > MMC: OMAP SD/MMC: > 0 > *** Warning - bad CRC, using default > environment > > > In: > serial > Out: > serial > Err: > serial > Beagle Rev > C4 > No EEPROM on expansion > board > timed out in wait_for_bb: > I2C_STAT=1000 > No EEPROM on expansion > board > Die ID > #5eca000700000000015154781801101e > musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, bulk combine, bulk split, > HB-ISO) > musb-hdrc: MHDRC RTL version > 1.400 > musb-hdrc: setup fifo_mode > 4 > musb-hdrc: 28/31 max ep, 16384/16384 > memory > USB Peripheral mode controller at 480ab000 using PIO, IRQ > 0 > Net: > usb_ether > Hit any key to stop autoboot: > 0 > mmc0 is current > device > gpio: pin 173 (gpio 173) value is > 1 > gpio: pin 7 (gpio 7) value is > 0 > SD/MMC found on device > 0 > reading > uEnv.txt > ** Unable to read file uEnv.txt > ** > reading > zImage > ** Unable to read file zImage > ** > Booting from nand > ... > > > NAND read: device 0 offset 0x280000, size > 0x400000 > 4194304 bytes read: > OK > Bad Linux ARM zImage magic! > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- LinkedIn - http://www.linkedin.com/in/maximpodbereznyy Company - http://www.linkedin.com/company/mentorel Facebook - https://www.facebook.com/mentorel.company -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
