On Fri, Nov 21, 2014 at 7:22 PM, Paul Reioux <[email protected]> wrote: > Hi BBB community, > > We have a BBB Clone hardware with only serial UART as the only communication > port to our board at the moment (USB port is not working due to hardware > issues) > > So this is where I am at this moment, looking for advice to go forward. > > HW Description: > > Chip: AM3358BZC100 > eMMC: Manufacturer ID: fe, OEM: 14e, MMC version 4.41 Capacity 1.8 GiB Bus > Width: 4-bit > UART Serial (only I/O to the board) > USB (broken due to hardware issues) > No SDCard expansion at all. > No I2C EEPROM > No Nand > > SW Setup/Progress: > > Powered up in UART boot mode > loaded u-boot-spl.bin via xmodem > then after spl is loaded, loaded u-boot.img via y-modem > > Uboot prompt is alive and working:
I'd say, find your best in-house solder person and bug wire the other microSD connector. Regards, -- Robert Nelson http://www.rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
