Could you tell me whether what kind of Issue I would have after running "make CROSS_COMPILE=arm-none-linux-gnueabi- ift" I'm getting two error, which is pertaining to arm gcc and the other is Error 127 start.io
On Wednesday, 18 May 2011 15:23:52 UTC-7, Jerry Doty wrote: > > I am building MLO from source using the following commands > (codesourcery 2009q1 tool-chain): > > git clone git://gitorious.org/x-load-omap3/mainline.git x-loader > cd x-loader > make CROSS_COMPILE=arm-none-linux-gnueabi- distclean > make CROSS_COMPILE=arm-none-linux-gnueabi- omap3530beagle_config > make CROSS_COMPILE==arm-none-linux-gnueabi- ift > > This creates an x-load.bin.ift file which I rename to MLO and install > to a microSD card following the instructions given at > http://elinux.org/BeagleBoardBeginners. > > The board boots and I get the standard U-boot banner of: > > U-Boot 2010.03 (May 18 2011 - 14:27:48) > > OMAP3630/3730-GP ES2.1, CPU-OPP2, L3-165MHz, > OMAP3 Beagle board + LPDDR/NAND > .. > > But I don't get an X-loader banner. Instead of seeing: > > Texas Instruments X-Loader 1.4.4ss (Mar 8 2011 - 08:51:11) > Beagle xM > Reading boot sector > Loading u-boot.bin from mmc > > I get garbage printed to the console. When I replace the MLO file I > generated with the binary that shipped with the board, it works. > > Has anyone hand luck re-building X-Loader (MLO) for the xM Rev C > board? If so, can you please offer some advice? > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
