Down grade to v3.8.x: (as said by Robert C Nelson) sudo apt-get update sudo apt-get install linux-image-3.8.13-bone68 sudo reboot
On Friday, 26 December 2014 22:24:13 UTC+5:30, [email protected] wrote: > > I have a user of my cape who tried to use the 3.14 beaglebone black based > Debian image. My instructions were for 3.8 so didn't work. So far I have > been unable to find a good summary on what I would need to do to convert > configuring using /sys/devices/bone_capemgr.* to the method used for 3.14. > Is 3.14 configuration still in flux so I should tell him to stick with 3.8 > for a while or is it reasonable now to convert? If so where do I find the > information on how to convert? I am using the PRUSS and various I/O pins > including the audio pins. > > What I found was using dtb-rebuilder to make a new device tree file for > the board. So far all I have been able to do is get errors like > Error: src/arm/mfm_read-00A0.dtsi:1.5-15 syntax error. Is dtb-rebuilder > the proper way or is a better way available? > > My board operated in two modes where I loaded the proper config file at > run time. Will people have to be putting in a new dtb file when they wish > to change mode and reboot? > > (My cape > http://www.pdp8online.com/mfm/dip_board/board_desc.shtml#swinstall) > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
