Hi, boot takes much longer with 69 kernel:
[ 0.767408] pinctrl-single 44e10800.pinmux: pin 44e10854 already requested by 44e10800.pinmux; cannot claim for gpio-leds.8 [ 0.779110] pinctrl-single 44e10800.pinmux: pin-21 (gpio-leds.8) status -22 [ 0.786380] pinctrl-single 44e10800.pinmux: could not request pin 21 on device pinctrl-single Loading, please wait... systemd-fsck[206]: BEAGLEBONE: clean, 35288/236176 files, 147950/943872 blocks [ 64.384719] libphy: PHY 4a101000.mdio:01 not found [ 64.389761] net eth0: phy 4a101000.mdio:01 not found on slave 1 What happens here? Also I get a kernel oops when shutting down: Detaching DM devices. [ 111.285531] (NULL device *): gadget not registered. [ 111.291442] Power down. [ 111.296139] Kernel panic - not syncing: Attempted to kill init! exitcode=0x00000000 [ 111.296139] [ 111.305707] [<c001125d>] (unwind_backtrace+0x1/0x98) from [<c049bfd3>] (panic+0x5b/0x160) All would be much simpler for me if CONFIG_DRM_LOAD_EDID_FIRMWARE=y would be enabled in kernel. So if any developer is reading this - please enable this in the next kernel please. It helps a lot to deal with some DVI monitors. Thanks! Am Donnerstag, 8. Januar 2015 11:55:45 UTC+1 schrieb Robert Kuhn: > > > Hi, > > thanks: > Linux beaglebone 3.8.13-bone69 #1 SMP Thu Jan 8 09:16:29 CET 2015 armv7l > GNU/Linux > > Just to be sure: I untar'd 3.8.13-bone69-modules.tar.gz and > copied 3.8.13-bone69.zImage to /boot/uboot/zImage. Is this enough? Whats > about 3.8.13-bone69-firmware.tar.gz and 3.8.13-bone69-dtbs.tar.gz? Do I > need them? > > Thanks! > > > Am Mittwoch, 7. Januar 2015 16:56:05 UTC+1 schrieb William Hermans: >> >> https://eewiki.net/display/linuxonarm/BeagleBone+Black >> >> On Wed, Jan 7, 2015 at 7:28 AM, Robert Kuhn <[email protected]> wrote: >> >>> Hi, >>> >>> I use the Bone Black with the current Debian firmware (2014-05-14). I >>> need to recompile the kernel to activate a specific feature. Whats the best >>> way to do this? Is there a description for this? >>> >>> Thanks! >>> >>> -- >>> For more options, visit http://beagleboard.org/discuss >>> --- >>> You received this message because you are subscribed to the Google >>> Groups "BeagleBoard" group. >>> To unsubscribe from this group and stop receiving emails from it, send >>> an email to [email protected]. >>> For more options, visit https://groups.google.com/d/optout. >>> >> >> -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
