Hi everyone, I'm new on this group, so I apologize if this question has been answered in one of previous discussions. I've searhed through the messages, but I couldn't find the answer.
I'm working on Beagle board, EBV Beagle, namely. I'm trying to switch to Barebox bootloader from standard X-loader / U-boot pair. I've checked out barebox source from *git://git.pengutronix.de/git/barebox.git* First, I've built MLO: *make ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- omap3530_beagle_xload_defconfigmake ARCH=arm CROSS_COMPILE=arm-linux-gnueabi-* then barebox.bin: *make ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- omap3530_beagle_defconfigmake ARCH=arm CROSS_COMPILE=arm-linux-gnueabi-* Both MLO and barebox.bin are copied in 128MB boot partition on SD card. I made Beagle board boot from SD card (holding USER key down when powering on), but all I got in serial terminal was: *beaglenand: Trying ONFI probe in 16 bits mode, aborting !nand: NAND device: Manufacturer ID: 0x2c, Chip ID: 0xba (Micron ), 256MiB, page size: 2048, OOB size: 64omap-hsmmc omap3-hsmmc0: registered as omap3-hsmmc0mci0: detected SD card version 2.0mci0: registered disk0malloc space: 0x87bff400 -> 0x87fff3ff (size 4 MiB)booting from MMC* As far as I can understand, MLO has sent those messages and tried to boot barebox from MMC, but then it all stopped. Has anyone had the similar situation? I have also enabled kernel low level debug messages and selected UART port 3 as OMAP debug UART port. Any idea and suggestion how to solve this issue is more than welcome. Mihajlo -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
