Thanks for the info. You have been much help. I checked mdio:00 and 01. 00 is there and has same SMSC info, 01 is not used so I assume this is normal message and can safely ignore.
On Wednesday, January 21, 2015 at 3:03:33 PM UTC-6, RobertCNelson wrote: > > On Wed, Jan 21, 2015 at 2:36 PM, <[email protected] <javascript:>> wrote: > > Apologize, no, we do not have NAND. we have eMMC on board, I was just > > referring to the info copied from the boot log > > > > Regarding mdio:00 I see no messages on boot log to this regard. Is there > a > > command I can query to check it? > > debian@beaglebone:~$ dmesg | grep mdio:00 > [ 1.119700] davinci_mdio 4a101000.mdio: phy[0]: device > 4a101000.mdio:00, driver SMSC LAN8710/LAN8720 > [ 29.275310] libphy: 4a101000.mdio:00 - Link is Up - 100/Full > [ 37.357496] libphy: 4a101000.mdio:00 - Link is Up - 100/Full > > debian@beaglebone:~$ dmesg | grep mdio:01 > [ 26.198636] libphy: PHY 4a101000.mdio:01 not found > [ 26.203680] net eth0: phy 4a101000.mdio:01 not found on slave 1 > [ 33.984396] libphy: PHY 4a101000.mdio:01 not found > [ 33.989465] net eth0: phy 4a101000.mdio:01 not found on slave 1 > [ 35.349652] libphy: PHY 4a101000.mdio:01 not found > [ 35.354716] net eth0: phy 4a101000.mdio:01 not found on slave 1 > > > Regarding the flasher script - THANKS A MILLION! I have now booted from > eMMC > > on board to debian. Much appreciated. I am not sure when I am supposed > to > > ground the WP, during flashing or after flashing? can you calrify? > > GND the pin before power up, it just holds the eeprom in a writeable > state.. On one of my test boards, i just ran a wire from the gnd on > the socket to it. > > > Also, is similar image for Angstrom available? > > I don't believe so.. > > With the u-boot patch, you should be able to piece one together. > > My eeprom flash routine is here: > > https://github.com/RobertCNelson/boot-scripts/blob/master/tools/eMMC/init-eMMC-flasher-v3.sh#L112 > > > The mid script reboot is a little tricky, as the eMMC doesn't load > unless you have a proper eeprom in v3.8.x. ;) > > Regards, > -- > Robert Nelson > http://www.rcn-ee.com/ > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
