Hello Graham!!!!! I referred this link & deleted the MLO file so that the board will boot from SD card...From then the Board is booting from SD card... but if i remove the SD card & try to connect to the system using USB it is not connecting.. I followed the above commands.. but i am not getting how can i add that MLO file back to the eMMC & in which directory to add that MLO file....
Any help appreciated much... Thanks & Regards Sagar On Monday, 9 February 2015 05:06:13 UTC+5:30, Graham wrote: > > Install one of the uSD card based distributions on a uSD card. > Boot from the uSD card, not the on-board eMMC. > > cd /mnt > > mkdir disk > > mount /dev/mmcblk1p2 disk > > cd disk > > and you will see the root file system on the eMMC. > go find what you broke, and fix it. > > sync > > shutdown > > remove the uSD and see if it boots from the eMMC. > > --- Graham > > == > > > On Sunday, February 8, 2015 at 1:17:12 PM UTC-6, [email protected] > wrote: >> >> >> I accidently modified uEnv.txt file located in eMMC of my Beaglebone >> black. Now the board is not booting. I can not even see BBB for serial >> connection from terra term (Windows 7 after drivers are installed). How can >> I get access to the board? If I can just access to uboot I could reflash or >> run it using nfs. Any ideas? >> > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
