Read the section in the System Reference Manual on considerations in the selection of I/O Pins. Particularly read the section on protecting the pins that are used by the BBB during boot. --- Graham
== On Monday, April 6, 2015 at 1:32:55 PM UTC-5, star...@gmail.com wrote: > > Hello there, I have been working on a robotics project using the > beaglebone black and have just run into some difficulty. > > I am using a protocape for holding all of my circuitry to various sensors. > While the protoboard is connected, the board turns on but does not boot. > When I disconnect the protocape, my board turns on and boots normally. This > happened in between runs with no changes made. > > I have changed batteries, disconnected different sensors, and do not have > my robotics routine running on start up. That is the extent of my > troubleshooting skills. > > Does anyone have any suggestions on what else to check? I don't know how > this could have happened with no changes made, but alas, this is what > happens two weeks before a project is due. > > Thank you in advance > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.