Thanks for your answer. My project goes only about a software solution to put all the data into an mysql and draw nice pictures with it ☺ The BeagleBoard has already an software device driver for w1 but this is imitated to 10 slaves per master and I have found somebody who talks about multiple w1-master-pins on one board but nobody writes an article how to configure it.
Von: Clark Leach [mailto:[email protected]] Gesendet: Donnerstag, 9. April 2015 00:16 An: [email protected] Cc: Rasp, Robert Betreff: Re: Multiple 1-Wire Pins That should have read "DS9490R" not "DS2490R"... On Wednesday, April 1, 2015 at 9:44:11 AM UTC-4, [email protected]<mailto:[email protected]> wrote: Hello, I use my BeagleBord Black to monitor my heating-system. I use DS18S20 as temperature sensors. In the moment there are 7 sensors connected but I need more of them. The 1-wire bus supports only 10. How can I have an other pin as a 1-wire-bus-master ? BTW: I describe my system on my webpage: http://www.powershell.pub/ds18b20/ It is in German language... Thank you Robert -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
