As written in the manual the 5V switch for the USB host port power will not. The board will be damaged.
Gerald On Sat, Jul 18, 2015 at 2:24 PM, Maxim Podbereznyy <[email protected]> wrote: > It should not get damaged because PMIC should handle voltage up to 20V as > written in its manual. > 16 Июл 2015 г. 17:30 пользователь "Gerald Coley" <[email protected]> > написал: > > Not knowing what is damaged, I would say replace the processor. If the LED >> is flashing that usually means the PMIC is OK, but not having it to look >> at, you may need to replace the PMIC also. >> >> Or you can request an RMA. >> >> Gerald >> >> >> On Thu, Jul 16, 2015 at 9:18 AM, Mübin Icyer <[email protected]> >> wrote: >> >>> Hello, >>> >>> I mistakenly connected 8V to USB mini connector of BBB board :) and it >>> is now not working. The blue power LED lights for a couple miliseconds I >>> think, then it does not light any more. I think the PMU (Power Management >>> Unit) detects a short circuit and switchs the power off. >>> How can I repair it? Which component shall I look? >>> >>> Thanks. >>> >>> -- >>> For more options, visit http://beagleboard.org/discuss >>> --- >>> You received this message because you are subscribed to the Google >>> Groups "BeagleBoard" group. >>> To unsubscribe from this group and stop receiving emails from it, send >>> an email to [email protected]. >>> For more options, visit https://groups.google.com/d/optout. >>> >> >> >> >> -- >> Gerald >> >> [email protected] >> http://beagleboard.org/ >> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> For more options, visit https://groups.google.com/d/optout. >> > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- Gerald [email protected] http://beagleboard.org/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
