Is this what you're after ? debian@beaglebone:~$ *sudo apt-get update*debian@beaglebone:~$
* sudo apt-get install setserial*debian@beaglebone:~$ * sudo setserial -g /dev/ttyS[0123]*/dev/ttyS0, UART: 8250, Port: 0x0000, IRQ: 155 /dev/ttyS1, UART: unknown, Port: 0x0000, IRQ: 0 /dev/ttyS2, UART: unknown, Port: 0x0000, IRQ: 0 /dev/ttyS3, UART: unknown, Port: 0x0000, IRQ: 0 Anyway, if you're unfamiliar with setserial I'd advise to run setserial -h *first*, and heed the warning near the end. On Mon, Jul 27, 2015 at 9:44 PM, <[email protected]> wrote: > Hi > > I am trying to get started with embedded linux. > I bought a Beagle bone black Rev C. It came with Debian linux kernel > version 3.8, > > I understand x86 architecture uses PC16550d IC UART hardware and its > register address can be seen in /proc/ioports. > > I was wondering if I can get information on UART hardware for BBB and its > corresponding register address > > Thanks. > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
