On Wed, Oct 7, 2015 at 9:35 AM, Sven Bock <[email protected]> wrote: > > > On Wed, Oct 7, 2015 at 4:20 PM, Roger Quadros <[email protected]> wrote: >> >> On 07/10/15 17:15, Sven Bock wrote: >> > Thank you so much for your support Roger. >> > I assume with the stock rom the D14 should turn on by default. >> > Could there be something set on the board, independent of the sd card? >> >> I can't think of anything like that. The kernel should drive the D14 line >> to the right state when the USB driver starts. >> >> I just tested mainline kernel on my beagleboard-xm rev.B and it worked >> fine. >> >> Which device tree blob are you loading with the kernel? For rev.C you need >> to >> load omap3-beagle-xm.dtb and not omap3-beagle-xm-ab.dtb > > > I used the command below for settting up the sd card as described on the > wiki > sudo ./setup_sdcard.sh --mmc /dev/sdb --dtb omap3-beagle-xm
This install's a version of u-boot that correctly detects the xmab vs xmc.. I use to carry a patch to fix ehci on v4.2.x, but this wasn't needed anymore on my xmc.. What board do you have? and can you add the serial log with the u-boot version? Regards, -- Robert Nelson https://rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
