Hello everyone. Recently I did an upgrade to the mainline rt kernel 4.1, following this instructions https://github.com/beagleboard/bb.org-overlays/blob/master/readme.md.
The upgrade process went well and after boot I was unable to access the board via usb ethernet. In fact the interface shows up as eth2 on my linux box, so I typed ifconfig eth2 up 192.168.7.1. Access was regained but after a while the interface will loose the ip address. So I had to reissue the ifconfig eth2 up command time after time. Another thing is that the pru was not enabled. This kernel has support for prussdrv? I tried to copy my old boneblack.dtb but I found out that it was not compatible... also I found two locations for dtb, one under /boot/dtbs and another at /boot/udev/dtbs... which one should I use? Thank you very much Carlos Novaes -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
