On Mon, Dec 21, 2015 at 10:11 PM, <[email protected]> wrote: > >> > Where are the User LED blink codes provided or documented? >> >> The only real LED blink code is on bootup, a solid pattern >> >> [] [] [] [] - off >> [x] [] [] [] - on, starting mmc scan... >> [x] [x] [] [] - scanning mmc... >> [x] [x] [x] [] - processed boot script... >> [x] [x] [x] [x] - jumping into boot... >> >> Beyond that, the "flasher" does a cyclon pattern... >> > OK, thanks. This is what I see (LEDs oriented to top of view). The device > has been sitting steady state for about an hour or two: > > [ethernet] [] [x] [] [] > > That's after the failed flash, after the reboot, with the microSD card > removed, and with the ethernet cable installed. > > Another state I encountered I could not find information on was the "2 short > blinks of all 4 LEDs followed by a long pause" (that was repeated). I > encountered it after the flashing operation but before the reboot. I let the > device sit 8 hours hoping it would eventually settle in the "4 LEDs all on" > state after the flash, but it never got there.
On average it takes about 5mins/GB to flash the eMMC.. So with the debian images, anything over 20 minutes and something has gone wrong.. > > Any ideas what state the device is in? > > (I'll start another thread (if needed) on recovery once I can research the > current state). > > ----- > > If it matters, the Debian 8.2 image (SHA256 47142683...) from [1] and the > instructions at [2] kinda got me here. I suspect the problem is mostly lies > in [2] because I found it to be very under-specified. > > [1] http://beagleboard.org/latest-images > [2] http://elinux.org/Beagleboard:BeagleBoneBlack_Debian#Flashing_eMMC For jessie 8.2, grab one of these: http://elinux.org/Beagleboard:BeagleBoneBlack_Debian#Debian_Image_Testing_Snapshots All the files marked as "eMMC-flasher" will flash the eMMC on bootup.. Everything else will just run from the microSD card.. (note you may have already ran one of these, but you just never logged in..) Regards, -- Robert Nelson https://rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
