Yes, that was a while back and is covered on the WikI. They were special screens when we first started. Max frequency and an AM3359 is 800MHz. These were screened for 1GHZ operation.
Gerald On Thu, Jan 7, 2016 at 10:34 AM, Robert Nelson <[email protected]> wrote: > > > On Thu, Jan 7, 2016 at 10:29 AM, Steve French <[email protected]> > wrote: > >> Gerald, >> Not sure why you say "You would need a new processor and memory for >> sure." The BBB uses the Sitara XAM3359AZCZ100, and according to page9 >> of this datasheet <http://www.ti.com/lit/ds/symlink/am3359.pdf>, it says >> it should operate down to -40degC. Even this eMMC datasheet >> <http://media.digikey.com/pdf/Data%20Sheets/Micron%20Technology%20Inc%20PDFs/EMMC_Series.pdf> >> says it will operate down to -20degC. >> > > I remember seeing a note/errata somewhere talking about "XAM3359xxxx" > where actually mis-silkscreen parts we used on the BBB.. > > Regards, > > -- > Robert Nelson > https://rcn-ee.com/ > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- Gerald [email protected] http://beagleboard.org/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
