On Tue, Feb 2, 2016 at 3:57 PM, Robert Nelson <[email protected]> wrote: > On Tue, Feb 2, 2016 at 3:39 PM, Wally Bkg <[email protected]> wrote: >> I think its pretty sweet to have node-red running "out of the box" but >> without the BoneScript access to the GPIO and A/D pins (I assume BoneScript >> PWM is still broken) its nowhere near as neat as it could be! > > GPIO & A/D can be accessed via config-pin > > root@beaglebone:~# config-pin -l P9.18 > default gpio gpio_pu gpio_pd spi i2c pwm > > >> >> If I "downgrade" to 3.8 kernel, what else is required to get BoneScript >> working beyond installing the Beaglebone nodes with npm? > > sudo apt-get install linux-image-3.8.13-bone79 > sudo reboot > > Bonescript is installed.. > >> I'm having issues with this image getting the "gadget" to connect -- it >> seems to only work from a cold start -- when I first plug it in the FAT >> partition mount but the gadget hangs "waiting for IP address" If I press >> reset it may or may not start after the reboot. So far its always started >> if I hold the powerbutton down until it shuts off, and then press it again >> to do a cold boot. > > Okay, that's different.. Starts flashing the clean image to do reset > button testing. ;) > > journalctl -f | grep kernel > Feb 02 15:52:54 hades kernel: sd 15:0:0:0: Attached scsi generic sg1 type 0 > Feb 02 15:52:54 hades kernel: sd 15:0:0:0: [sdb] 81920 512-byte > logical blocks: (41.9 MB/40.0 MiB) > Feb 02 15:52:54 hades kernel: sd 15:0:0:0: [sdb] Write Protect is off > Feb 02 15:52:54 hades kernel: sd 15:0:0:0: [sdb] Mode Sense: 0f 00 00 00 > Feb 02 15:52:54 hades kernel: sd 15:0:0:0: [sdb] Write cache: enabled, > read cache: enabled, doesn't support DPO or FUA > Feb 02 15:52:54 hades kernel: sdb: sdb1 > Feb 02 15:52:54 hades kernel: sd 15:0:0:0: [sdb] Attached SCSI removable disk > push reboot... > Feb 02 15:53:53 hades kernel: usb 5-1.4: USB disconnect, device number 8 > Feb 02 15:53:53 hades kernel: rndis_host 5-1.4:1.0 enx7c669d4bac92: > unregister 'rndis_host' usb-0000:00:10.1-1.4, RNDIS device > Feb 02 15:53:53 hades kernel: sd 15:0:0:0: [sdb] Synchronizing SCSI cache > Feb 02 15:53:53 hades kernel: sd 15:0:0:0: [sdb] Synchronize Cache(10) > failed: Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK > Feb 02 15:54:18 hades kernel: usb 5-1.4: new high-speed USB device > number 9 using xhci_hcd > Feb 02 15:54:18 hades kernel: usb 5-1.4: New USB device found, > idVendor=1d6b, idProduct=0104 > Feb 02 15:54:18 hades kernel: usb 5-1.4: New USB device strings: > Mfr=3, Product=4, SerialNumber=5 > Feb 02 15:54:18 hades kernel: usb 5-1.4: Product: BeagleBoneBlack > Feb 02 15:54:18 hades kernel: usb 5-1.4: Manufacturer: Circuitco > Feb 02 15:54:18 hades kernel: usb 5-1.4: SerialNumber: 0C-2414BBBK0103 > Feb 02 15:54:18 hades kernel: rndis_host 5-1.4:1.0 eth0: register > 'rndis_host' at usb-0000:00:10.1-1.4, RNDIS device, 7c:66:9d:4b:ac:92 > Feb 02 15:54:18 hades kernel: cdc_acm 5-1.4:1.2: ttyACM0: USB ACM device > Feb 02 15:54:18 hades kernel: usb-storage 5-1.4:1.4: USB Mass Storage > device detected > Feb 02 15:54:18 hades kernel: scsi host16: usb-storage 5-1.4:1.4 > Feb 02 15:54:18 hades kernel: rndis_host 5-1.4:1.0 enx7c669d4bac92: > renamed from eth0 > Feb 02 15:54:18 hades kernel: IPv6: ADDRCONF(NETDEV_UP): > enx7c669d4bac92: link is not ready > Feb 02 15:54:19 hades kernel: scsi 16:0:0:0: Direct-Access Linux > File-Stor Gadget 0401 PQ: 0 ANSI: 2 > Feb 02 15:54:19 hades kernel: sd 16:0:0:0: Attached scsi generic sg1 type 0 > Feb 02 15:54:19 hades kernel: sd 16:0:0:0: [sdb] 81920 512-byte > logical blocks: (41.9 MB/40.0 MiB) > Feb 02 15:54:19 hades kernel: sd 16:0:0:0: [sdb] Write Protect is off > Feb 02 15:54:19 hades kernel: sd 16:0:0:0: [sdb] Mode Sense: 0f 00 00 00 > Feb 02 15:54:19 hades kernel: sd 16:0:0:0: [sdb] Write cache: enabled, > read cache: enabled, doesn't support DPO or FUA > Feb 02 15:54:19 hades kernel: sdb: sdb1 > Feb 02 15:54:19 hades kernel: sd 16:0:0:0: [sdb] Attached SCSI removable disk > yank power.... > Feb 02 15:54:39 hades kernel: usb 5-1.4: USB disconnect, device number 9 > Feb 02 15:54:39 hades kernel: rndis_host 5-1.4:1.0 enx7c669d4bac92: > unregister 'rndis_host' usb-0000:00:10.1-1.4, RNDIS device > Feb 02 15:54:39 hades kernel: sd 16:0:0:0: [sdb] Synchronizing SCSI cache > Feb 02 15:54:39 hades kernel: sd 16:0:0:0: [sdb] Synchronize Cache(10) > failed: Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK > Feb 02 15:55:07 hades kernel: usb 5-1.4: new high-speed USB device > number 10 using xhci_hcd > Feb 02 15:55:07 hades kernel: usb 5-1.4: New USB device found, > idVendor=1d6b, idProduct=0104 > Feb 02 15:55:07 hades kernel: usb 5-1.4: New USB device strings: > Mfr=3, Product=4, SerialNumber=5 > Feb 02 15:55:07 hades kernel: usb 5-1.4: Product: BeagleBoneBlack > Feb 02 15:55:07 hades kernel: usb 5-1.4: Manufacturer: Circuitco > Feb 02 15:55:07 hades kernel: usb 5-1.4: SerialNumber: 0C-2414BBBK0103 > Feb 02 15:55:07 hades kernel: rndis_host 5-1.4:1.0 eth0: register > 'rndis_host' at usb-0000:00:10.1-1.4, RNDIS device, 7c:66:9d:4b:ac:92 > Feb 02 15:55:07 hades kernel: cdc_acm 5-1.4:1.2: ttyACM0: USB ACM device > Feb 02 15:55:07 hades kernel: usb-storage 5-1.4:1.4: USB Mass Storage > device detected > Feb 02 15:55:07 hades kernel: scsi host17: usb-storage 5-1.4:1.4 > Feb 02 15:55:07 hades kernel: rndis_host 5-1.4:1.0 enx7c669d4bac92: > renamed from eth0 > Feb 02 15:55:07 hades kernel: IPv6: ADDRCONF(NETDEV_UP): > enx7c669d4bac92: link is not ready > Feb 02 15:55:08 hades kernel: scsi 17:0:0:0: Direct-Access Linux > File-Stor Gadget 0401 PQ: 0 ANSI: 2 > Feb 02 15:55:08 hades kernel: sd 17:0:0:0: Attached scsi generic sg1 type 0 > Feb 02 15:55:08 hades kernel: sd 17:0:0:0: [sdb] 81920 512-byte > logical blocks: (41.9 MB/40.0 MiB) > Feb 02 15:55:08 hades kernel: sd 17:0:0:0: [sdb] Write Protect is off > Feb 02 15:55:08 hades kernel: sd 17:0:0:0: [sdb] Mode Sense: 0f 00 00 00 > Feb 02 15:55:08 hades kernel: sd 17:0:0:0: [sdb] Write cache: enabled, > read cache: enabled, doesn't support DPO or FUA > Feb 02 15:55:08 hades kernel: sdb: sdb1 > Feb 02 15:55:08 hades kernel: sd 17:0:0:0: [sdb] Attached SCSI removable disk > > humm, really no difference here.. can you do the same with your device?
Okay, now this is weird.. Testing the white, same as the black.. Start testing the green.. The "reset" button doesn't 100% work... Except when i want it to fail to work.. seems like a slight delay... (looking at serial debug, while hitting reset) yet still usb/gadget/mass/acm comes up every time.. running: 4.3.0-1-amd64 on my host.. Regards, -- Robert Nelson https://rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
