On Mon, Feb 22, 2016 at 9:16 AM, Jecika <[email protected]> wrote: > Hello everyone, > > > > I bought a BBB (rev C from element14) and tested it: at start up, the USERS > leds blinks. > > --> Normal behaviour > > > I have tried to update the flash image (with debian 7.9 distribution) by > following the instructions in the site Beagleboard:Updating The Software - > eLinux.org. > > I unplagged the power supply and I keep pressed the S2 button (boot) (at > least 1 minute), I Applied the power to the board by plugging in the cable > (external power supply 5 V, 3 A). Only power led is on. > > When I pressed the power button for at least 8 seconds, the power led is > turned off then after 3-4 seconds it is turned on. > > > > When I connect the BBB to UART port, I see the character 'CCCCCC' > periodically, what does it mean?
It just means the card was in-correctly flashed.. Please confirm which tool you used to flash and what command you use to flash it.. (mostly likely you dd'ed to the partition "/dev/sdX1" vs the drive "/dev/sdX") Regards, -- Robert Nelson https://rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
