Hello, We have a custom, BBB based board, which, when all relevant patches and PMIC settings have been applied, will power-cycle when poweroff is issued (remains off for a couple of seconds, and powers on again. The strange thing is that if we have the UART0 Tx pin connected to a PC, when poweroff is issued, the board powers off normally. Apparently, connecting the Tx causes some bleed that drops the voltage levels, that otherwise do not fall off adequately fast. Would anyone have any ideas as to what could be done to resolve this?
Thank you. BR, Nikos -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
