I am also going through my Replicape Delta setup. Slow but getting results. One thing to note is that your bed probe will always be the opposite of the top end-stops. So if your top end-stops are connected and configured for CCW (counter-clock-wise) then your bed probe will be CW (clock-wise). It is the way the motors turn.
For example, my end-stops config below (pin probe with microswitch) end_stop_X1_stops = x_ccw end_stop_Y1_stops = y_ccw end_stop_Z1_stops = z_ccw end_stop_Z2_stops = x_cw, y_cw, z_cw You should try and join the Thing-printer google group which is where quite a few replicape users visit. No need but very helpful group of people. On Monday, March 21, 2016 at 4:15:21 PM UTC, lenny72 wrote: > > Hi, > > I've started using the beaglebone recently and bought the replicape rev B3 > to hook it to a delta printer. > > I am wondering if anyone is also having problems with getting the z-probe > to work? I use a inductive 5v end-stop. On the hardware side everything > is working, it shows in the terminal when i trigger the z-probe. But > doesn't react when it is probing. > > I connected the probe to z2, and modified the config file: > "end_stop_Z2_stops = x_ccw, y_ccw, z_ccw". > > Any help would be appreciated > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
